Important Notes - Dalian Tenghui Innovative Construction Materials Co., Ltd

Tips

When transporting, loading and unloading products, the lengthwise direction of the sidings shall be working as the load-carrying side, with careful handling, collision and damage of sidings shall be avoided; when transporting the single sheet, the siding shall be erected for handling, so that the siding shall be avoided for deformation.
The deck of the vehicle must be smooth; after the level loading, the product shall be well fixed, and the damage of the product caused by the excessive binding when being fixed shall be avoided;
In the transportation process, vibration should be reduced; collision and exposure to the rain shall be prevented.
The environment for laying the siding products should be ventilated and dry, the ground must be flat and solid;
When adopting the square wood for support pad, it should be ensured that product shall not deform;
When laying in the open air, the water-proof sheet shall be used to fully cover the products;
When storing, it should be kept far away from the high temperature or high humid area, it is forbidden to have the mixed storage with oil,chemicals etc. of corrosion materials.
When opening the product package, firstly it should be laid horizontally, and unsealing should be done from the top of the product package, the siding sheets shall be taken out from the top to the bottom;
Do not take out the siding sheets from the side of the unsealing, so that scratch of the product surface can be avoided.
After the cutting of the siding sheet, the siding surface and incision may be attached with the cutting iron scraps, it may easily rust, the residual iron scraps should be cleared off.
When in construction, the siding surface should be well protected; scratch and bump should be avoided.
In the construction process, it should be prevented that the internal of the siding contacts water, in order to avoid that the internal water shall be seeped from the surface, which shall cause the corrosion and rust on the siding surface, reduce its service life.
The application should be avoided in the high temperature, high humidity, and acidic substance emission area. (such as boiler, combustion chamber, hot spring, and paper mill etc.).
For the handrail, AC through-wall pipe and condensed water pipe etc. extruding the wall, before the installation of the sidings, the reserved corresponding dimensions shall be made; the construction opening shall not be done after the installation of the sidings.
If the wall surface has AC, air outlet etc. of facilities for support component, its electric welding process shall be implemented before the laying of the sidings and insulation materials.
Do not install the siding under the base layer of the cement.
When in construction, the spacing of the vertical installation of timber frames shall be no larger than 500mm; the spacing of the horizontal installation of timber frames shall be no larger than 500mm.
Tenghui siding accessories shall be used for Tenghui siding installation.
For the screws used for installation, it is suggested the galvanized materials should be used.
When installing the sidings, the corresponding texture shall be aligned.
Interface slots should be installed in full length as an entire one without cutoff in the middle.
The siding surface stains caused during the construction should be cleaned using neutral detergent, so that lacquer thinner may be avoided to damage the siding finishing paint.

If the siding finishing paint has scratch, the special paint should be applied for repair.
For safety purposes, when in construction, the live conductors and other live electrical sources are forbidden to approach the sidings.

HOME

NEWS

ABOUT US

About Us

Distributor Wanted

CONTACT

Contact Us